Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!ssbell!mcmi!unocss!zycor!bill
From: bill@zycor.UUCP (bill)
Newsgroups: comp.unix.xenix
Subject: VPIX over serial lines (again)
Keywords: VPIX
Message-ID: <74@zycor.UUCP>
Date: 22 Dec 89 22:27:49 GMT
Organization: zycor, inc. omaha, nebraska
Lines: 23


Thanks for everyone who responded to my original problem:

	I run vpix on a serial line and the terminal goes "beep beep"
	and just hangs there. A kill -1 on vpix is the only way out.

I spent most of today taking my system all the way back to a
clean installation of everything. Along the way I tried various
things. The end result is that vpix works just fine over the 
serial line until that point where I install "Update A", which
takes the system from 2.3.2 to 2.3.3 (UFJ Disk) and VPIX from 
1.1.0 to 1.1.1. I install UFJ and things are still OK. I install
the two disks of Update A and the problem mysteriously reappears.
(Yes, I did follow the instructions... :-) )

Anyone else have a similar problem with this update? If not I am
going to assume that I have something funny in my hardware (?)


-- 
Bill Mahoney
bill@zycor.UUCP
The holiday season: time to wonder if the Salvation Army has tanks...