Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!rutgers!att!cbnewsc!slk
From: slk@cbnewsc.ATT.COM
Newsgroups: comp.unix.xenix
Subject: Help on changing swap space size
Keywords: divvy, NSWAP, how to?
Message-ID: <12533@cbnewsc.ATT.COM>
Date: 2 Jan 90 18:51:29 GMT
Reply-To: slk@cbnewsc.ATT.COM ()
Followup-To: skennedy@ihlpb.att.com
Distribution: na
Organization: AT&T Bell Laboratories
Lines: 22


HELP!  Does anyone know how to use 'divvy' or 'configure' to change the 
NSWAP size parameter?? 

Scenario: 386/16 NEC box, SCO XENIX 2.2.2(with upgrade K to 2.2.3), 
66Meg Drive, 4Meg/32bit RAM, 3 users, no \u filesystem. (I know, I know,
what a stupid thing to do...)

The disk crashed lately (haven't figured that one out yet) and had to 
re-install the disk. I wasn't paying attention when I allocated swap
space because the number is set too low (runs measurably slower). So how 
do I reallocate the NSWAP variable without having to re-install the 
disk again??

(Oh, I already RTFM, but wasn't too much help on using divvy or configure)

Thanks in advance, 

Shawn Kennedy
slk@cbnewsc.ATT.COM
skennedy@ihlpb.ATT.COM
att!ihlpb!skennedy