Xref: utzoo misc.wanted:7342 comp.sys.cbm:3789 sci.electronics:9157
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!rutgers!cmcl2!esquire!masters
From: masters@esquire.UUCP (Bruce Masters)
Newsgroups: misc.wanted,comp.sys.cbm,sci.electronics
Subject: Okidata 82A switch settings
Keywords: Okidata 82A
Message-ID: <1694@esquire.UUCP>
Date: 26 Dec 89 14:46:43 GMT
Organization: DP&W, New York, NY
Lines: 20

I have aquired an Okidata 82A printer. The printer appeared to be configured
to run on the serial interface. I need to use the built in parallel interface.
There are dip switches on the front pannel and also on the board in the back.
I also noticed a couple jumpers on the back board. Does anyone have any info
on these switches and jumpers? Any info would be greatly appreciated. Also,
does anyone know where I can purchase replacement ROMs to get this Okidata to
do bit mapped graphics? Thanks for your time.

				

Bruce Masters
212-530-4119	work
201-584-0954	home


-- 
                             Bruce A. Masters 
}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{
            uucp ===> {pyrnj, pyrtech, uunet, cmcl2}!esquire!masters
}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{}{