Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!psuvax1!psuvm!UNMCVM!FULLRICH From: FULLRICH@UNMCVM.BITNET (Fred Ullrich) Newsgroups: bit.listserv.sas-l Subject: Axis Specifications in G3D Message-ID: Date: 11 Jan 90 18:26:39 GMT Sender: "SAS(r) Discussion" Reply-To: Fred Ullrich Lines: 15 Approved: NETNEWS@PSUVM Gateway I am producing a 3-dimensional plot using PROC G3D and would like to be able to exert some control over the tick marks displayed on the axes. Specifically, I wish to reverse the order of the ticks on the 'Y' axis. Unlike PROC GPLOT, PROC G3D does not support use of the HAXIS or VAXIS statements. The only solution i've arrived at is to create negative values for the variable -- but this makes the axis label confusing. If you are aware of any solutions, I would appreciate reading them. I am using version 5.18 on VM/HPO. Thanks. Fred Ullrich (FULLRICH@UNMCVM) Department of Computing Services University of Nebraska Medical Center Omaha, NE 68198-5030 "The geographical center of the cultural universe"