Path: utzoo!utgpu!ugw.utcs.utoronto.ca!CUVMA!SWL-L Date: Wed, 10 Jan 90 23:53:15 EST Reply-To: Gary Lee Sender: Short Wave Listener's List From: postmaster@CUVMB.CC.COLUMBIA.EDU Subject: Re: voice-activated tape recorders X-To: swl-l@cuvmb.cc.columbia.edu To: UofToronto LAN redistribution Message-ID: <90Jan11.084551est.58713@ugw.utcs.utoronto.ca> Newsgroups: bitnet.swl-l Distribution: ut Approved: devnull@gpu.utcs.toronto.edu > I purchased a CTR-82 recently and found it activates only from the built-in > microphone and the mic input jack, but not the auxillary jack. This is > using a Sony 2010 from the recorder jack and a Bearcat 200XLT from the > earphone jack. It works fine this way but I don't understand why plugging > into the aux jack doesn't activate it also. The manual indicates it should > work this way. Anyone else finding the same on their CTR-82? > > *_______________*_________________________________________*_______KNH1CA_____* > | Steve Dowman | Email: s_dowman@leaf.enet.dec.com | Home: | > | d|i|g|i|t|a|l | -or- s_dowman%leaf.dec@decwrl.dec.com | 145 Coburn Woods | > | Littleton, MA | -or- ...!decwrl!leaf.dec.com!s_dowman | Nashua, NH 03063 | > *~~~~~~~~~~~~~~~*~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~*~~~~~~~~~~~~~~~~~~* Alright! already. I've seen the parts layout and the AUX jack _IS_ VOX controlled. The failure to work with some units will probly be traced to the levels leaving the units being much to low. Maybe some people can't find the high sensitivity selector.