Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!rutgers!orstcs!upas.CS.ORST.EDU!shepard
From: shepard@upas.CS.ORST.EDU (Mark N. Shepard)
Newsgroups: comp.sources.wanted
Subject: WANTED: Generic FORTH for MC680x0
Message-ID: <14682@orstcs.CS.ORST.EDU>
Date: 6 Jan 90 01:22:56 GMT
Sender: usenet@orstcs.CS.ORST.EDU
Reply-To: shepard@upas.CS.ORST.EDU (Mark N. Shepard)
Organization: Oregon State Univ. - CS - Corvallis, OR
Lines: 17

I'm looking for the source-code for a simple generic FORTH for the 68000.
When I say "simple" I mean my system has small memory, no disk drives,
and no operating system--in other words, a classic FORTH system.  

The system I want this for is a homebrew single-board-computer with
68030 / 68881 FPU, 160k SRAM (128k 32-bits wide + 32k 8-bit wide),
32k of EPROM, two rs232 serial ports, and a few other dodads.  
So far all I've got for software is a system-monitor/debugger.

I would really appreciate information on where I could get a listing
of FIG-FORTH or FORTH-79 (preferrably in machine-readable form from
someplace on the net),  or perhaps source-code for FORTH for a commercial 
system like the Amiga or Atari ST which I could strip down.

Thanx,

/* Mark shepard@cs.orst.edu | Oregon State University | Computer Engr Dept */