Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!cs.utexas.edu!romp!auschs!cello!d75!sabre!robin From: robin@sabre.uucp (Robin D. Wilson/1000000) Newsgroups: comp.sys.amiga Subject: Re: GVP Impact A500. Summary: Thanks on the .info, and Falcon still doesn't work. Message-ID: <2916@d75.UUCP> Date: 7 Jan 90 00:13:29 GMT References: <1088@crash.cts.com> Sender: news@d75.UUCP Reply-To: robin@reed.UUCP (Robin D. Wilson) Organization: IBM AWD, Austin, TX Lines: 32 >In article <1088@crash.cts.com> lgreen@pnet01.cts.com (Lawrence Greenwald) writes: >Save the Icon, then (the important step!!) >Rename it as "Disk.info". It MUST be this name for it to take effect!! >Do a re-boot and you should have your new icon. Thanks, that worked. Also it solved my problem with the inability to save the window set-up. Boy this is neato stuff. On to the probs, I can't remember is it was you, or somebody else who suggested that I check to make sure falcon wasn't assigning the falcon: directory in the startup-sequence. I re-installed falcon on my HD and this time left it where the install script put it. It still doesn't help. I counted the lines this time between the instruments and the scenery window, there is a 4 pixel wide line across the screen from the left-to-right. And several instruments (especially noticable on the "warning" indicator light) are not as they should be -- they have some- thing wrong with them. Has anuybody else seen this problem, or should I call Spectrum HoloByte? +-----------------------------------------------------------------------------+ |The views expressed herein, are the sole responsibility of the typist at hand| +-----------------------------------------------------------------------------+ |USNail: UUCP: | |2323 Wells Branch Pkwy., #G107 cs.utexas.edu!romp!ibmchs!auschs\ | |Austin, TX 78728 !sabre.austin.ibm.com!robin | |Home: (512)251-6889 ^^^^^^^^^^^^^^<-MUST BE INCLUDED| +-----------------------------------------------------------------------------+