Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!sunybcs!uhura.cc.rochester.edu!merlin.cvs.rochester.edu!jea
From: jea@merlin.cvs.rochester.edu (Joanne Albano)
Newsgroups: comp.sys.amiga.tech
Subject: Re: speeding up the amiga and hardware hacking
Summary: Problems with processor accelerators
Message-ID: <4706@ur-cc.UUCP>
Date: 8 Jan 90 00:45:16 GMT
References: <90005.150000NETOPRBH@NCSUVM.BITNET>
Sender: news@uhura.cc.rochester.edu
Reply-To: jea@cvs.rochester.edu (Joanne Albano)
Organization: Univ. Roch. Center for Visual Sci.
Lines: 21

Is there a known cause for the incompatibility of the
Microbotics Starboard and Processor Acclerators such as
the CSA and CMI? We have a A1000 with grounded PALS and
a Starboard/Stardrive combo and when we install the CMI
processor with 14Mhz 68000 with 68881 it fails until
we uninstall the Starboard. It reads Kickstart and prompts
for the Workbench disk but then soon puts up the Guru
Screen with error = 3.00200E8A. The CMI works without
the starboard and the starboard works without the CMI.

Any ideas? We have not yet terminated the bus because we 
have found no information on how to do this?

Thanks for any help you can give. 
Joanne


 Joanne Albano, Center for Visual Science     (716) 275-3055
 Room 256 Meliora Hall, Univ. of Rochester, Rochester NY 14627 
 UUCP: {rutgers,allegra,decvax}!rochester!ur-cvsvax!jea
 INTERNET: jea@snipe.cvs.rochester.edu