Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!SFAUSTIN.BITNET!Z4648252
From: Z4648252@SFAUSTIN.BITNET (Z4648252)
Newsgroups: comp.sys.atari.st
Subject: Megas in clone cases...
Message-ID: <900104.09355056.038329@SFA.CP6>
Date: 4 Jan 90 15:35:52 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 17

Hello all,

    If anyone has any experience on working with clone cases, contact
me.  Specifically, I'm moving a Mega 4 and a hard drive mechanism into
a baby AT case.  The only problem I'm encountering is really cosmetic
and that is where I need help.
    The problem comes in the ports.  I'm wondering if the expansion
slot blank covers can be purchased with DB25 and din holes.  Other than
the ports, the project is complete (duh, what's an ST without ports?).
Everything else looks "factory", turbo switch, reset switch, etc.  Just
the port area.  If I can't find any slot covers with holes, I'll have to
make my own somehow.  Again, the problem is purely cosmetic but I'd like
to make the case look "factory".  I could have the existing ST cables
run out and through the back but that wouldn't look good.
    If anyone can offer some advice please contact me.  THANKS!!!

Larry Rymal:  |East Texas Atari 68NNNers| <Z4648252@SFAUSTIN.BITNET>