Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!tut.cis.ohio-state.edu!cs.utexas.edu!asuvax!mcdphx!mcdchg!ddsw1!corpane!disk!rob From: rob@disk.UUCP (Rob Miracle) Newsgroups: comp.sys.ibm.pc Subject: Re: Quattro Pro Summary: No real problems here Message-ID: <985@disk.UUCP> Date: 31 Dec 89 16:29:37 GMT References: <2798@isis.UUCP> <89Dec29.120622est.2641@neat.cs.toronto.edu> Organization: Digital Information Systems of Ky (DISK), Louisville, Ky Lines: 40 In article <89Dec29.120622est.2641@neat.cs.toronto.edu>, bradb@cs.toronto.edu (Brad Brown) writes: > aburt@isis.UUCP (Andrew Burt) writes: > > >Has anyone had any problems with Quattro Pro... such as it completely not > >working? > > Are you using DOS 3.3? I don't have Quatro Pro yet, but I have Reflex 2.0, > which also uses the VROOM (VROOOM?) memory management scheme. I found that > if I didn't add "stacks=0,0" to my CONFIG.SYS file, Reflex would crash while > translating an old database to the new format. It probably would have crashed > in other places too -- I never tried. I have ran Q-Pro on three different machines: IBM-PS/2 Model 30 / DOS 3.3 Clone 386/VGA / DOS 3.3 Zenith 286 (Big Box)/VGA / Zenith DOS 3.3+ I have yet to see it lock up any where. Here is the config.sys from my 386: BREAK=ON FILES=30 BUFFERS=20 DEVICE=C:\UTILITY\NNANSI.SYS DEVICE=C:\DOS\VDISK.SYS 3072 512 128 /E DEVICE=C:\TC\TDH386.SYS SHELL=C:\COMMAND.COM /P /E:1024 I think that I have a STACKS command in the config.sys of the model 30 and I am unsure about the Zenith. Also the NNANSI.SYS was not in my config when I was testing Q-Pro on the 386. The only problem that I have encountered with it is that on my Clone VGA (Excelogic VGA/16 Adapter) is that the cursor in Graphics Mode tends to get left all over the place. But then again.... It worked fine on the Zenith VGA. Rob -- * Rob Miracle * ...uunet!ukma!corpane!disk!rob * * Disk Inc. (502)968-5401 - 5406 * Discaimer: I don't claim any of my actions * "Baseball is an activity, Football is a Sport." -- George Carlin