Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!ut-emx!ibmchs!auschs!awdprime!woan.austin.ibm.com!ron
From: ron@woan.austin.ibm.com (Ronald S. Woan)
Newsgroups: comp.sys.ibm.pc
Subject: Everex RAM-3000 (was Re: can I put four floppies in an AT clone)
Keywords: everex ram memory extended expanded
Message-ID: <1259@awdprime.UUCP>
Date: 4 Jan 90 23:23:01 GMT
References: <88@slvblc.UUCP> <GOLDSTN.89362204630@MAINE.BITNET> <10767@ucsd.Edu> <4597@hydra.gatech.EDU>
Sender: news@awdprime.UUCP
Reply-To: @cs.utexas.edu:ibmchs!auschs!woan.austin.ibm.com!ron
Organization: IBM-Austin, AWD
Lines: 17

In article <88@slvblc.UUCP>, dick@slvblc.UUCP (Dick Flanagan) writes:
|>I have two of the Everex RAM-3000 boards.  They are EXTended memory boards,
|>*not* EXPanded memory boards.  LIM in any form is not supported on the board.

Maybe we aren't all talking about the same board. I bought a RAM-3000
(PLUS) a few months ago and it has EMS4.0 (Expanded Memory) support
with driver. I have this nasty suspicion that it had hardware for 3.2,
as that was what the manual indicated. ELIM 4.0 was only in the
Addendum that was tacked on. I don't have any applications that make
use of the 4.0 functions, but it run LIM 3.2 stuff fine.

					Ron

+-----All Views Expressed Are My Own And Are Not Necessarily Shared By------+
+------------------------------My Employer----------------------------------+
+ Ronald S. Woan  (IBM VNET)WOAN AT AUSTIN, (AUSTIN)ron@woan.austin.ibm.com +
+ outside of IBM       @cs.utexas.edu:ibmchs!auschs!woan.austin.ibm.com!ron +