Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!tut.cis.ohio-state.edu!n8emr!cmhgate!f200.n226.z1.FIDONET.ORG!ADAM.FRIX From: ADAM.FRIX@f200.n226.z1.FIDONET.ORG (ADAM FRIX) Newsgroups: comp.sys.mac Subject: Re: comp.mac.binaries (should be comp.bin Message-ID: <36254.25A82D35@cmhgate.FIDONET.ORG> Date: 5 Jan 90 05:22:30 GMT Sender: ufgate@cmhgate.FIDONET.ORG (newsout1.26) Organization: FidoNet node 1:226/200 - Aurora Borealis, Gahanna Oh Lines: 33 Edgar Knapp writes: EK> >I noticed that a demo of Raymond Lau's latest commerical effort EK> >is showing up in comp.mac.binaries in ten parts. I've also EK> >noticed other people say that their free software is stuck in the EK> >queue for comp.mac.binaries. As much as I admire Mr. Lau's work, EK> >I wonder if it's "right" that a demo of his commerical product EK> >takes up a lot of bandwidth in comp.mac.binaries when there is a EK> >lot of other stuff that could be sent out. "Commerical use of the EK> >net" is overused at times, but such demos seem to fall under that EK> >category. Bandwidth is being used to advertise and sell a EK> >commerical product. EK> EK> I could very well do completely without crippleware or commercial EK> stuff on comp.binaries.mac. At least it should be the policy to EK> give these postings the lowest possible priority. I guess it didn't bother me too much, one way or the other. If the decision came down to strike such stuff, I don't think I'd yell or scream or anything. On the other hand, if it comes through, oh well. I guess my attitude in this case is tempered by the fact that this "demo" of Ray Lau's ShortCut is NOT crippleware, but rather a demo done in a HyperCard stack. I think I do agree that I, and the world, could do without crippleware. That sounds like a good starting place for restricting commerical stuff, at any rate. Give the commercial stuff low priority, fine. That makes perfect sense. --Adam-- -- ADAM FRIX via cmhGate - Net 226 fido<=>uucp gateway Col, OH UUCP: ...!osu-cis!n8emr!cmhgate!200!ADAM.FRIX INET: ADAM.FRIX@f200.n226.z1.FIDONET.ORG