Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!ucbvax!hoptoad!tim From: tim@hoptoad.uucp (Tim Maroney) Newsgroups: comp.sys.mac.hardware Subject: Re: SIMM removal tool Message-ID: <9573@hoptoad.uucp> Date: 9 Jan 90 14:56:58 GMT References: <8221@dime.cs.umass.edu> <50537@bbn.COM> <37675@apple.Apple.COM> Reply-To: tim@hoptoad.UUCP (Tim Maroney) Organization: Eclectic Software, San Francisco Lines: 28 In article <37675@apple.Apple.COM> marc@Apple.COM (Mark Dawson) writes: >You can save a lot of money, time, plus get a longer warantee by putting in >SIMMs yourself--BUT you risk breaking the SIMM socket. If you do this, you'll >need to replace the whole logic board, which will cost WAY more than the $$ you >saved by doing the replacement yourself. The SIMM tool was designed to help >reduce this breakage problem and speeds up the removals to boot. I'm hesitant to admit that I know this, but breaking the clips on the SIMM socket does not ruin the motherboard. Electrician's tape works perfectly well to hold SIMMs in place, as long as you don't make a habit of transporting your Mac. You do not have to replace the motherboard; just stretch the tape from edge to edge. I've opened the computer a few times since then and there has not been any melting. But in any case, I haven't noticed that the labor charges for installing SIMMs are very high, so I'm not sure the statement about saving "a lot" of money is true either. (I haven't paid such charges myself, but I have some non-gearhead friends who have. $120 per SIMM including installation. A lot of mail-order places charge that just for the SIMMs with no installation.) It's what, about ten minutes of labor? Even at $60/hour that's not very much. -- Tim Maroney, Mac Software Consultant, sun!hoptoad!tim, tim@toad.com "But don't you see, the color of wine in a crystal glass can be spiritual. The look in a face, the music of a violin. A Paris theater can be infused with the spiritual for all its solidity." -- Lestat, THE VAMPIRE LESTAT, Anne Rice