Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!usc!chaph.usc.edu!aludra.usc.edu!cyamamot
From: cyamamot@aludra.usc.edu (Cliff Yamamoto)
Newsgroups: comp.sys.mac.hardware
Subject: Re: what TORQX is needed to open a Mac SE?
Message-ID: <7339@chaph.usc.edu>
Date: 11 Jan 90 18:03:16 GMT
References: <2816@cerberus.oakhill.UUCP>
Sender: news@chaph.usc.edu
Distribution: comp
Organization: University of Southern California, Los Angeles, CA
Lines: 11

In article <2816@cerberus.oakhill.UUCP> hunter@oakhill.UUCP (Hunter Scales) writes:
>Subject says it all.  I need to open my SE to add RAM.

Ahh, I had just asked this a couple months ago to sci.electronics.
You need a T-15 Torx driver at least 8" long (to get the top two screws).
If you need addresses, I've got my past articles/email saved.  Let me know.

Cliff

P.S.  Don't forget to clip/remove the 150 ohm "256K RAM" resistor if you're
      adding 1 Mb SIMMS.