Path: utzoo!attcan!uunet!tut.cis.ohio-state.edu!ucbvax!nabla.electrical-engineering.umist.ac.uk!cs
From: cs@nabla.electrical-engineering.umist.ac.uk (Chris Stops)
Newsgroups: comp.sys.transputer
Subject: peek and poke operations on a pre-booted transputer
Message-ID: <9001121549.a029764@nabla.electrical-engineering.umist.ac.uk>
Date: 12 Jan 90 15:49:37 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 15


Can anyone tell me the order of the bytes when peeking and poking a
pre-booted transputer? The transputer reference manual merely
says (for a T212)...

   "...the first two byte word is taken as the address...etc"

...but what order are those bytes in? Low byte first or last?
Similarly for the T4?

While I'm here, what can anyone tell me about the Atrai ABAQ ?

Thanks in advance.....

Chris Stops    cs@uk.ac.umist.electrical-engineering.nabla