Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!bpa!cbmvax!grr
From: grr@cbmvax.commodore.com (George Robbins)
Newsgroups: gnu.gcc.bug
Subject: Re: Problems building GCC 1.36 on Ultrix 3.0
Message-ID: <9290@cbmvax.commodore.com>
Date: 11 Jan 90 08:41:03 GMT
References: <88@ucunix.SAN.UC.EDU>
Reply-To: grr@cbmvax.commodore.com (George Robbins)
Organization: Commodore, West Chester, PA
Lines: 15

In article <88@ucunix.SAN.UC.EDU> rainwatr@ucunix.san.uc.edu (Don Rainwater) writes:
> I've been trying to build GCC 1.36 on a VAX 8650 running Ultrix 3.0.
> According to the installation instructions, all I need to do is type
> 'config.gcc vax', followed by 'make' to generate the stage1 compiler.

This isn't a very helpful answer, but I've made gcc a number of times
without any particular problems.  I'd start over, making sure you dot
the i's, etc.  Also, make sure defineitions for which ld, cpp and so on
that gcc is using are rational and there's not some confusion about your
path.

-- 
George Robbins - now working for,	uucp: {uunet|pyramid|rutgers}!cbmvax!grr
but no way officially representing	arpa: cbmvax!grr@uunet.uu.net
Commodore, Engineering Department	fone: 215-431-9255 (only by moonlite)