Xref: utzoo comp.sys.mac.hardware:1026 sci.electronics:9285 comp.os.cpm:3079 Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!rice!uw-beaver!sumax!amc-gw!sigma!flash!bill From: bill@flash.UUCP (William Swan) Newsgroups: comp.sys.mac.hardware,sci.electronics,comp.os.cpm Subject: Re: IBM bus to SCSI adaptor//IOMEGA controller transplant Message-ID: <369@flash.UUCP> Date: 5 Jan 90 01:53:09 GMT References: Reply-To: bill@flash.UUCP (William Swan) Organization: The Keith Highlanders Pipe Band, Seattle WA Lines: 25 In bergman@m2c.m2c.org (Michael Bergman) writes: >Has anyone fooled around with IOMEGA "Bernoulli Box" drives? I am >wondering whether I can adapt a cheap 10 + 10 drive originally >intended for the IBM PC to work with my Mac. [...] I have one of the Bernoulli Box (10+10) drives for the PC. It is on my list of things to fool around with (perhaps a hard drive for my auld CP/M box - I actually had one running on it many years ago, somebody else marketed the design...). The controller board in this one has every appearance of using a SCSI interface (although the unit I hooked up to the CP/M box years ago had a SASI interface instead). I unfortunately have no documentation on the interface command set - the unit has a controller board for the PC (does not seem to work on an AT, haven't tried it with a PC yet) and associated software. Still, given a working configuration I don't see it being that difficult to adapt to some other system - assuming the interface from that system is not too difficult. -- Bill Swan bill@Summation.WA.COM Send postal address for info: Innocent but in prison in Washington State for 13.5 years: Ms. Debbie Runyan: incarcerated 01/1989, scheduled release 07/2002. In now: 0 years, 11 months, 2 weeks, 1 day.