Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!umich!samsung!brutus.cs.uiuc.edu!wuarchive!psuvax1!psuvm!UKCC!WILSON
From: WILSON@UKCC.BITNET (Randy Wilson)
Newsgroups: bit.listserv.novell
Subject: RE Zenith 386/16 and EMS
Message-ID: <NOVELL%90020511014834@SUVM.BITNET>
Date: 5 Feb 90 15:05:08 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 13
Approved: NETNEWS@PSUVM Gateway


     I am using a 386/16 with the 4 meg board for a workstation with
a WD8003E ethernet card and ran into the same troubles with Zenith's
ems.sys.  Zenith tech support told me that ems.sys uses D000 as the
address to set up expanded memory.  Unfortunately that is the same address
that we use for the shared memory in the 8003 shell.  I haven't gotten
around to trying to gen another shell using a different address to see if
that would work.

Randy Wilson (wilson@ukcc.uky.edu)
analyst/programmer
Dept of Physiology
University of Kentucky