Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!umich!samsung!brutus.cs.uiuc.edu!wuarchive!psuvax1!psuvm!UFPINE!WOOGIE
From: WOOGIE@UFPINE.BITNET
Newsgroups: bit.listserv.novell
Subject: Re: Novell & Zenith Expanded Memory
Message-ID: <NOVELL%90020608271350@SUVM.BITNET>
Date: 6 Feb 90 12:23:00 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 18
Approved: NETNEWS@PSUVM Gateway
Original_To:  JNET%"novell@suvm"


        Thanks to everyone who offered suggestions.  I am now able to use
qemm.sys.  I set the switches as follows:

device=qemm.sys fr=d000 on ma=2 ha=32 nv ns x=c000-cfff x=e000-e7ff x=b000-b7ff

Most of these switches came from the local Zenith rep.  However, the real
problem I have had is that, for some reason, if the packet driver is loaded
higher in memory than the ems driver, then nothing seems to work.  Originally,
I was loading the packet driver like this:

wd8003e 0x60 0x3 0x280 0xd000

and qemm at c800.  I have since switched this and all works fine now.

Thanks again for the help.

Mike