Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!psuvax1!psuvm!ERENJ!CGTAYLO
From: CGTAYLO@ERENJ.BITNET (Clement Taylor)
Newsgroups: bit.listserv.novell
Subject: Two ethernet boards in 1 server on the same physical network
Message-ID: <NOVELL%90020610194393@SUVM.BITNET>
Date: 2 Feb 90 21:02:58 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 12
Approved: NETNEWS@PSUVM Gateway

I hope this is an easy question requiring a very short answer.
I want to put a second ethernet board in my 2.15C ANW server and
connect it to the same network as the first board. I want to
ECONFIG the new board so I can experiment with the BYU packet driver.

SHOULD I USE A DIFFERENT NETWORK ADDRESS WITH THE SECOND BOARD or
should I assign a new address much as I have done with the Interlan
TCP/IP gateway that I have on another server? I know that I could try
both and see what works but development time on the server in question
is quite limited.

Thanks, Clem Taylor