Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!QM01.CTD.ORNL.GOV!Wolfgang_Naegeli.ED_TSRS
From: Wolfgang_Naegeli.ED_TSRS@QM01.CTD.ORNL.GOV (Wolfgang Naegeli)
Newsgroups: comp.protocols.appletalk
Subject: RE> Telnet/MacTCP/Appletal
Message-ID: <9002061745.AA14595@oaunx1.CTD.ORNL.GOV>
Date: 6 Feb 90 20:46:56 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 27


         Reply to:   RE> Telnet/MacTCP/Appletal
>Can anyone else say if the NCSA(BYU) TelNet/MacTCP/Appletalk  
>combination has shown such problems?

I have a similar problem with freezing sessions in InterCon's
TCP/Connect (which is based on NCSA Telnet)  It happens both in
Telnet sessions and while doing client FTP.  I have not tried opening
another session. I cannot close the session window, but the menus
still seem to be active and when I select Quit, I usually get "The
application TCP/Connect has unexpectedly quit (1)" or a system
crash.
This happened using the MacTCP version.  I just switched to using the
non-MacTCP version a few days ago, and haven't seen the problem recur,
but as I say, I may just have been lucky. I have had a couple times since
then when it quite after I told it to capture the session, but that may
be an unrelated problem.
I am running on a Mac II over LocalTalk KFPS-2U with K*Star and KIP
(atalkad) on a MicroVAX (though I don't think the latter should make a
difference since it is not really involved directly.  I am using a
static address.
I hope this gives someone another clue what might be wrong.

Wolfgang N. Naegeli
Oak Ridge National Laboratory
Internet: wnn@ornl.gov    Bitnet: wnn@ornlstc
Phone: 615-574-6143       Fax: 615-574-3895