Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!DUKEMC.BITNET!DMPM
From: DMPM@DUKEMC.BITNET (James Dryfoos- PostMaster)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Getting parity error 2 using 3c503 and NCSA
Message-ID: <E4A8AA5A349F0000A3@dukemc>
Date: 2 Feb 90 19:12:00 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 8

I have been running NCSA 2.3b4 on my AT over a 3c503
for awhile without problem.  However, I just moved board
and software to my XT.  The boards diagnostics check out
fine.  But when I try to TELNET it reads the config file
and then I get a parity error 2 and have to power down.
Any ideas?  I tried changing interrupts but it made no diff.

-Jim Dryfoos