Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!ucbvax!van-bc!ubc-cs!alberta!calgary!ccu!eeserv.ee.umanitoba.ca!chan
From: chan@eeserv.ee.umanitoba.ca (Andrew Chan Ph# 275-2456)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Settings to use SLIP with NCSA Telnet 2.3b4
Message-ID: <1990Feb4.203656.4908@ccu.umanitoba.ca>
Date: 4 Feb 90 20:36:56 GMT
Sender: news@ccu.umanitoba.ca
Reply-To: chan@eeserv.ee.umanitoba.ca (Andrew Chan Ph# 275-2456)
Organization: Electrical Engineering, U of Manitoba, Winnipeg, Manitoba, Canada
Lines: 15

Greetings:

I am trying to use the SLIP packet driver with NCSA Telnet 2.3b4.  I have
so far only managed to get a "cannot initialize board" error.

What I did:

1. slip8250 0x61 slip 4 0x3f8 9600 3000 3000

2. telbin -s
   and it complains about not being abot to initialize board (error code -2)

What do I have to put in config.tel except "hardware=packet"?

Any hints will be very much appreciated...