Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!tut.cis.ohio-state.edu!ucbvax!bloom-beacon!snorkelwacker!ira.uka.de!smurf!ccave!jh
From: jh@ccave.UUCP (Juergen Hermann)
Newsgroups: comp.sys.amiga
Subject: Re: Assign & Path (Sometimes)
Message-ID: <182@ccave.UUCP>
Date: 31 Jan 90 05:13:57 GMT
References: <8915@nigel.udel.EDU>
Reply-To: jh@ccave.UUCP (Juergen Hermann)
Organization: Chameleon's Cave, Karlsruhe, FRG
Lines: 14

In article <8915@nigel.udel.EDU> jwhitman@stl-06sima.army.mil (Jerry Whitman) writes:
>To use it I added the line Execute S:WPAssigns immediately prior to the
>ENDCLI command on BOOT:S/Startup-Sequence.  After I boot I bring up the

When you do an EndCLI, the CLI is closed (you know that). When you close
a CLI, all local data is lost (the path is local data, you didn't knew
that, did you?).

So add "Execute S:WPAssigns" to your S:Startup-Shell (if you have one,
create it otherwise), this should solve your problem.

--
   //  Juergen Hermann          UUCP: ira.uka.de!smurf!ccave!jh
 \X/   75 Karlsruhe 1, FRG      Fido: 2:241/2.1212@FidoNet