Xref: utzoo comp.sys.amiga:49252 comp.sys.amiga.tech:9799
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!uflorida!beach.cis.ufl.edu!rmy
From: rmy@beach.cis.ufl.edu (Rasthiyaadu Yakaa)
Newsgroups: comp.sys.amiga,comp.sys.amiga.tech
Subject: HELP - installing INBOARD on A1000
Message-ID: <22139@uflorida.cis.ufl.EDU>
Date: 6 Feb 90 22:07:36 GMT
Sender: news@uflorida.cis.ufl.EDU
Reply-To: rmy@beach.cis.ufl.edu ()
Distribution: usa
Organization: UF CIS Department
Lines: 25


Hi! here's hoping someone in netland can help me on this one.

I obtained a Spirit INBOARD IN1000 for my A1000 recently. The whole
package looks somewhat incomplete. The package contained the board
, a disk, and a sheet with some diagrams (for the A500). There were
no mounting screws, etc... The board itself is for the 1000 (it is
L-shaped) and so is the disk. BUT not the accompanying diagram sheet.

Question: could someone please send me a copy of the correct diagrams
(send me email, if you feel you can make a copy and send it to
me). Also, is it necessary for me to buy some mounting devices (screws, 
bolts,..). 

When I install the board, is it necessary for me to ground the PALs, etc.
If so, any info (e-mail) will be appreciated.

Lastly, can anyone point out a reliable source for the 256x1 chips that
the board needs. If anyone needs to sell some ==)

If this topic is not of interest to a larger group, e-mail response is OK.

Thanks (in advance)

Yas