Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!jarthur!brutus.cs.uiuc.edu!samsung!cs.utexas.edu!rutgers!mcnc!kajihara
From: kajihara@mcnc.org (Lord of Sith)
Newsgroups: comp.sys.cbm
Subject: Kermit connect help wanted
Message-ID: <1613@speedy.mcnc.org>
Date: 1 Feb 90 20:02:12 GMT
Organization: MCNC; RTP, NC
Lines: 16

I have had the kermit program that I downloaded for a while without any use
because it seemed to have problems.  This is v2.2 (72) [I think].  I am using
it with a Hayes compatible modem connected via an RS-232 interface.  I may be
wrong in this, but I assume that after entering connection mode I should be
able to enter Hayes AT commands.  I have tried this without anything connected
via the joystick ports.  My problem:  I cannot get certain characters to echo
to the screen among which are 'a' and 'd' which does not help much.  Any
suggestions?

     Scott Kajihara

-- 
     Scott Akira Kajihara
mcnc!kajihara  kajihara@mcnc.org  mcnc!pyvax!kajihara  mcnc!pymvjb!kajihara
kajihara@ncsuphys.BITNET _et. al._ of which I am not aware.
     Insanity is a prerequisite for physics techie-types