Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!mips!apple!agate!ucbvax!hplabs!hpfcso!hpldola!ppa
From: ppa@hpldola.HP.COM (Paul P. Austgen)
Newsgroups: comp.sys.ibm.pc
Subject: Re: BocaRAM expansion board
Message-ID: <11250127@hpldola.HP.COM>
Date: 1 Feb 90 15:56:54 GMT
References: <5190071@hplsla.HP.COM>
Organization: HP Elec. Design Div. -ColoSpgs
Lines: 6

I tried this board, but without the extra I/O ports.  I had a AT
clone that I believe runs the bus at full processor speed, 10 Mc.

The board did not work unless parity was disabled.  This no doubt
was the fault of the bus design, but nonetheless, an AST Rampage
board works just fine.