Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!sharkey!math.lsa.umich.edu!zaphod.mps.ohio-state.edu!uwm.edu!psuvax1!psuvm!CCCLAN!MARK
From: MARK@CCCLAN.BYU.EDU (Mark Ungerman)
Newsgroups: bit.listserv.novell
Subject: Re: What drive is assigned to the LOGIN Directory?
Message-ID: <34428760@ccclan.byu.edu>
Date: 7 Feb 90 21:12:40 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: MARK@ccclan.byu.edu
Lines: 8
Approved: NETNEWS@PSUVM Gateway
X-To:         NOVELL@SUVM.ACS.SYR.EDU

You can use DOS command LASTDRIVE to set where your network drives
will begin.  This command is issued in the CONFIG.SYS file and has the
syntax LASTDRIVE= x where X is any letter A through Z.  If you specify
LASTDRIVE = G then your network drives will begin with H:  Good Luck!

Mark Ungerman
Technical Coordinator
BYU Computer Consultation Center