Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!psuvax1!psuvm!USUHS!THOMAS
From: THOMAS@USUHS.BITNET
Newsgroups: bit.listserv.novell
Subject: SYSCON HANGING
Message-ID: <NOVELL%90021211303479@SUVM.BITNET>
Date: 12 Feb 90 15:30:00 GMT
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 14
Approved: NETNEWS@PSUVM Gateway
Original_To:  BITNET%"novell@suvm"
Original_cc:  THOMAS

In reply to Tim Munroe's problem regarding SYSCON hanging.

I had the same problem when I installed my LAN.  I found that I had a TSR
that was competing with SYSCON.  My problem was the order in which IPX, NET3
and Sidekick were loaded.  If you load Sidekick before IPX and NET3 SYSCON
hangs up.  If you load Sidekick after IPX and NET3 SYSCON runs just fine.

Check and see if you have a memory resident program that is causing the problem.
Load IPX and NET3 before any other memory resident routines.  SYSCON should
run just fine.

JERRY THOMAS
USUHS
THOMAS@USUHS