Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!psuvax1!psuvm!CARLETON!TIM_MUNRO
From: Tim_Munro@CARLETON.CA
Newsgroups: bit.listserv.novell
Subject: SYSCON HANGING
Message-ID: <900212.15172170.031549@CU.CP6>
Date: 12 Feb 90 20:05:04 GMT
References: SYSCON HANGING
Sender: Novell LAN Interest Group <NOVELL@SUVM>
Reply-To: Novell LAN Interest Group <NOVELL@SUVM>
Lines: 12
Approved: NETNEWS@PSUVM Gateway
In-Reply-To:  <900212.11391167.030810@CU.CP6>


      Hmm, not the case here. Our 'boot disk' consists of PC-DOS v3.30
   IPX.COM and NET3.COM and that's all.  I did notice,  however,  that
   the version of NET3.COM is Rev A (as shipped with NOS Rev.C) So the
   system is as naked  as  possible,  with  only  the stuff as sent by
   novell,  with  the  one  exception of the WD8003  drivers.  All  is
   configured normally nothing  fancy and nothing special.  At first I
   though it was the auto-boot roms on the WD cards,  but this is  not
   the case. I booted normally with a floppy and the problem persists.

   Tim      <Tim_Munro@carleton.ca> Fax:(613) 788-4448
                                  Voice:(613) 788-3722