Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!uwm.edu!zaphod.mps.ohio-state.edu!brutus.cs.uiuc.edu!wuarchive!psuvax1!psuvm!VM1!PIERRE From: PIERRE@VM1.MCGILL.CA (Pierre Goyette - The NET3270 Man) Newsgroups: bit.listserv.novell Subject: SHELL.CFG options Message-ID: Date: 14 Feb 90 00:51:04 GMT Sender: Novell LAN Interest Group Reply-To: Novell LAN Interest Group Lines: 24 Approved: NETNEWS@PSUVM.BITNET Gateway The Supervisor Reference for 2.15 Rev. C has two options for the SHELL.CFG file called: PRINT HEADER = # PRINT TAIL = # These commands set the buffer size that hold the escape characters that are sent to the printer before and after a print job. This sounds real nice, but where in ^%&^* do you specify these supposed print headers and tailers??? The only header I know is the RESET header (or other ones) that you define using PRINTDEF and PRINTCON. Did I miss something, or did Novell forget to add some code here? Pierre Goyette domain: pierre@vm1.mcgill.ca Network Analyst bitnet: pierre@mcgill1 McGill University Computing Centre FAX: (514) 398-6876 805 Sherbrooke St. W. Montreal, Quebec H3A 2K6 (514) 398-7354