Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!rutgers!mailrus!uwm.edu!zaphod.mps.ohio-state.edu!brutus.cs.uiuc.edu!psuvax1!psuvm!EBAY!CLAIREC
From: clairec@EBAY.SUN.COM (Claire Castell)
Newsgroups: bit.listserv.sas-l
Subject: Graphics Vertical Axis Label
Message-ID: <9002072042.AA02585@zydeco.EBay.Sun.COM>
Date: 7 Feb 90 20:42:50 GMT
Sender: "SAS(r) Discussion" <SAS-L@OHSTVMA>
Reply-To: Claire Castell <clairec@EBAY.SUN.COM>
Lines: 25
Approved: NETNEWS@PSUVM Gateway
Comments: To: SAS-L%VTVM2.BITNET@VTVM1.CC.VT.EDU

I suspect this is easy for someone out there:
I would like my verical axis label to be up and down on the side
of some graphs and I know to do this I specify some combination
of the ANGLE=  and ROTATE= options described in the F.M. (SAS/GRAPH 6.03)
However, I can't seem to come up with the right combination to do this
and and I'm spending too much time on it.(whine)

	V
	E
	R
	T
	I
	C
	A
	L

	A
	X
	I
	S
		HORIZONTAL  AXIS

Thanks for your support.
Claire Castell
Sun Microsystems, Inc.