Path: utzoo!utgpu!jarvis.csri.toronto.edu!rutgers!cs.utexas.edu!wuarchive!decwrl!shelby!lindy!news
From: LC.YRS@forsythe.stanford.edu (Richard Stanton)
Newsgroups: comp.emacs
Subject: Re: IBM/PC jove.rc file
Message-ID: <7997@lindy.Stanford.EDU>
Date: 12 Feb 90 07:45:52 GMT
Sender: news@lindy.Stanford.EDU (News Service)
Distribution: usa
Lines: 17

In article <7261@ogicse.ogc.edu>,
scottb@ogicse.ogc.edu (Scott Baker) writes:
>I'm using JOVE version 4.13 on my PC clone.  The jove.rc file is not read
>unless it is in the current working directory.  Is there a system variable
>that I can set to remedy this?
>
>                        Thanks in Advance:
>
>                        Scott Baker

The APPEND command (gives PATH like capabilities to data files) may
work. I used a similar program found on wsmr-simtel20.army.mil,
which worked fine (unless you start in a directory which contains a
different JOVE.RC, in which case this will be found before the data
path gets searched).

Richard Stanton