Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!samsung!zaphod.mps.ohio-state.edu!van-bc!ubc-cs!alberta!calgary!ccu!eeserv!chan
From: chan@eeserv (Andrew Chan Ph# 275-2456)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Re: Settings to use SLIP with NCSA Telnet 2.3b4
Message-ID: <1990Feb6.063313.8461@ccu.umanitoba.ca>
Date: 6 Feb 90 06:33:13 GMT
References: <1990Feb4.203656.4908@ccu.umanitoba.ca>
Sender: news@ccu.umanitoba.ca
Reply-To: chan@eeserv.UUCP (Andrew Chan Ph# 275-2456)
Organization: Electrical Engineering, U of Manitoba, Winnipeg, Manitoba, Canada
Lines: 11

In article <1990Feb4.203656.4908@ccu.umanitoba.ca> chan@eeserv.ee.umanitoba.ca (Andrew Chan Ph# 275-2456) writes:
>Greetings:
>
>I am trying to use the SLIP packet driver with NCSA Telnet 2.3b4.  I have
>so far only managed to get a "cannot initialize board" error.
>

I found my problems....  I figured it out by looking into config.tel of
the clarkson version.  I guess we just need a better documented config.tel
file.  But since this is a beta version, I don't think we can blame
anyone.. :-)