Path: utzoo!utgpu!jarvis.csri.toronto.edu!clyde.concordia.ca!uunet!zephyr.ens.tek.com!uw-beaver!ubc-cs!alberta!calgary!ccu!eeserv!chan
From: chan@eeserv (Andrew Chan Ph# 275-2456)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Settings to use SLIP with NCSA Telnet 2.3b4 (again)
Message-ID: <1990Feb6.082811.18131@ccu.umanitoba.ca>
Date: 6 Feb 90 08:28:11 GMT
References: <1990Feb4.203656.4908@ccu.umanitoba.ca> <1990Feb6.063313.8461@ccu.umanitoba.ca>
Sender: news@ccu.umanitoba.ca
Reply-To: chan@eeserv.ee.umanitoba.ca (Andrew Chan Ph# 275-2456)
Organization: Electrical Engineering, U of Manitoba, Winnipeg, Manitoba, Canada
Lines: 43

I am still having trouble in trying to get SLIP to work under NCSA Telnet
ver 2.3b4.

1. I've successfully got 2 hardwired PC's to talk SLIP using Ka9q.

2. I am now trying to get 1 PC to use NCSA and the other Ka9q.

3. I've connected (null'ed) pin 4 to 5 on the NCSA end.

On the NCSA end:

- I did a "slip8250 0x60 slip 4 0x3f8 9600 3000 3000" and
  my settings in config.tel on the NCSA end:

	hardware=packet
	ioaddr=60
	address=6	# I suppose 6 is for slip

- I run "telbin -s" and then try "ftp" to it from the ka9q end-- nothing!

- I exited and ran procomm and checked that packets did come in from the
  ka9q end.

- I run "procomm" on the ka9q end and then:
  I "telbin" and try to open a session to the ka9q end-- nothing shows up
  on the procomm screen of the ka9q end and the connection timed out.

Again the NCSA end:

"slip8250 0x60 1 4 0x3f8 9600 3000 3000" and in config.tel:
	hardware=packet
	ioaddr=60
	address=1 # what is 1 for anyways?  ethernet?

It then actually sent something along the wire when I tried to open a
session to the ka9q end... though ka9q never recorgnize those packets.

I then "telbin -s" and try "ftp" to it from the ka9q end and again
nothing....

--- I then _GAVE_UP_ and sent out this query.. :-) :-(

Help will be very much appreciated....