Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!ames!pacbell!sorinc!magik From: magik@sorinc.UUCP (Darrin A. Hyrup) Newsgroups: comp.sys.amiga Subject: Re: Conner CP-340 Message-ID: <9002110930.AA04776@sorinc.UUCP> Date: 11 Feb 90 10:30:39 GMT References: <7702@sun.acs.udel.edu> <26764@cup.portal.com> <22800@usc.edu> <19369@grebyn.com> <9064@portia.Stanford.EDU> Reply-To: magik@sorinc.PacBell.COM (Darrin A. Hyrup) Followup-To: comp.sys.amiga Lines: 59 In article <9064@portia.Stanford.EDU> mmaston@portia.Stanford.EDU (Michael Maston) writes: >OK guys, now that you have provided me with the specs on the CP-340, maybe >one of you could provide me with the uses of the 7 jumpers on the front >(the end without the power and SCSI connector) of the drive. I figured out >from trial and mostly error that there are four jumpers on the controller >board that set the SCSI address, but I have no idead what these others are. Okay, the four jumpers on the controller are not just the SCSI address. However, you shouldn't need to mess with anything besides these four in getting it to run correctly. The jumper settings are labeled E1 through E4 (going from right to left I believe, looking from the "front"). They are: E1: Parity (installed disables parity) E2 - E4: SCSI device Device # E2 E3 E4 ---------------------------------- 0 In In In 1 Out In In 2 In Out In 3 Out Out In 4 In In Out 5 Out In Out 6 In Out Out 7 Out Out Out >I wouldn't care but the damn thing is hanging my controller's software when >it reads that address. Anyway, I will be talking to Pacific Peripherals about >the software hangs, but the info on those jumpers would really help! If its hanging, first check the SCSI ID on both the software/controller, and the CP340. They should probably be both set to "0". Once thats done, check if your controller needs parity enabled or disabled (usually doesn't matter), and if that fails, check to make sure the scsi 50 pin connector is installed correctly. Conner uses a reversed pattern SCSI connector, so Pin 1 is located closest to the power supply connector, instead of at the other end like some others. I believe there is a lock on the SCSI connector itself, so it should fit only in one way, but its best to make sure. If that fails, you might check to make sure that both the formatting software and the controller are set up right to handle the CP-340 (and are working right). I know Microbotics needed to make special allowances (they put out a new ROM revision on the Hardframe [1.3C for Conner]) to make it work right. >Thanks, > >Mike Hope that helps, Darrin Hyrup -- Darrin A. Hyrup // AMIGA Enthusiast rencon!esfenn!dah magik@sorinc.PacBell.COM \X/ & Software Developer pacbell!sorinc!magik ========================================================================== "Speak little and well, if you wish to be considered as possessing merit."