Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!wuarchive!decwrl!ucbvax!ASTRO.PSU.EDU!antunes
From: antunes@ASTRO.PSU.EDU (Alex Antunes)
Newsgroups: comp.sys.amiga
Subject: Help!  K directive!
Message-ID: <9002120640.AA29085@astro.psu.edu>
Date: 12 Feb 90 06:40:26 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Lines: 24

Hello.  Serious problem time.
I have an A500 with kickstart1.2 and a hard drive.  I have my bootup disk
run bindrivers, mount dh1:, then execute startup-sequence on dh1: which
then handles everything else.
I had a system lockup.  I couldn't fix it, so I turned off the computer,
then turned it backon 30 seconds later.
Now, when it gets to the line of the bootup disk of "execute dh1:s/startup-
sequence" it errors out, saying
EXECUTE no K directive
execute failed returncode 20

Now, at this point if I manually type "execute dh1:s/startup-sequence" it
continues along fine.
Well,not really fine... it crashes at my next execute in the startup
file, but i found if i start GOMF3.0 running it never has a problem there.

So, how can I fix this K directive problem?  And, as a bonus question, why
does it guru at the next execute if I don't have gomf running, but works
fine if I do?
               thanks, one and all.                  sandy
------------
Sandy Antunes   "the Waupelani Kid" 'cause that's where I live...
antunes@astro.psu.edu                 Penn State Astronomy Dept
--- "once in a lifetime there comes a time... but this ain't it" ---