Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!uwm.edu!lll-winken!decwrl!shelby!portia!mmaston
From: mmaston@portia.Stanford.EDU (Michael Maston)
Newsgroups: comp.sys.amiga.hardware
Subject: Contiguous drives under volume name
Message-ID: <9124@portia.Stanford.EDU>
Date: 13 Feb 90 02:11:21 GMT
References: <25d757a7.1460@polyslo.CalPoly.EDU>
Sender: Michael Maston <mmaston@portia.stanford.edu>
Reply-To: mmaston@portia.Stanford.EDU (Michael Maston)
Distribution: usa
Organization: Stanford University
Lines: 16


This may be a strange question but, I just became the proud owner of several
Conner CP-340 hard drives and I am installing them in my A2000 with the
Seagate ST-277N already there.  I was thinking that it is somewhat annoying 
to have to have several volumes (DH0:, DH1:, DH2:, etc).  Is it possible
in the Mountlist to just list all the drives (Unit #, cylinders, etc) under
one volume name such as DH0: and have all the separate hard drives appear
as one huge contiguous drive?

I haven't found anything in the manuals about something like this, but it
sure would be convenient!


Any ideas are welcome!

Mike