Path: utzoo!attcan!uunet!samsung!zaphod.mps.ohio-state.edu!rpi!leah!bingvaxu!bingsunl.cc.binghamton.edu!consp24
From: consp24@bingsunl.cc.binghamton.edu (consp24)
Newsgroups: comp.sys.cbm
Subject: Re: Kermit v2.2 problems
Keywords: C-128 screen driver with C-128D
Message-ID: <2939@bingvaxu.cc.binghamton.edu>
Date: 8 Feb 90 05:06:18 GMT
References: <1624@speedy.mcnc.org>
Sender: usenet@bingvaxu.cc.binghamton.edu
Reply-To: consp24@bingsunl.cc.binghamton.edu (consp24)
Organization: SUNY Binghamton
Lines: 19

>I have downloaded kermit v2.2 again from Q-link and can get it to work
with the
>C-64 80 column screen.  However, because I have an 80 column monitor and a
>C-128D computer, I would like to use the C-128 screen driver.  My problem is
>that in connect mode, characters like 'A' and 'D' are not echoed to the
screen.
>This is a system with nothing connected via the joystick ports.  Previous
>replies to an earlier post suggested that this was a local echo problem; this
>is not the case as echo is on.  Any help would be appreciated.

I, too, have this problem with my C-128D.  And nothing is plugged in to any
ports.  A, D, G, and a few other characters come up as ^A, ^D, ^G etc.
This is a very frustrating problem (esp. with ^At^Dt number!)

Gregg W. Riedel     CONSP24 @ BINGVAXA, BINGVAXU, BINGSUNS
Student Consultant - State Univ. of New York at Binghamton
----------------------------------------------------------
"There are few personal problems that can't be solved by a
suitable application of high explosives."