Xref: utzoo comp.unix.xenix:10024 comp.unix.i386:2885
Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!iuvax!rutgers!ispi!jbayer
From: jbayer@ispi.UUCP (Jonathan Bayer)
Newsgroups: comp.unix.xenix,comp.unix.i386
Subject: Re: Second ST506 controller with Xenix 386AT (2.3.2)
Message-ID: <1307@ispi.UUCP>
Date: 12 Feb 90 12:29:00 GMT
References: <1990Feb12.005307.10870@metro.ucc.su.oz.au>
Followup-To: comp.unix.xenix
Organization: Intelligent Software Products, Inc.
Lines: 20

dawes@extro.ucc.su.oz.au (D H Dawes) writes:


>I am trying to add a second ST506 hard disk controller to my 386 running
>Xenix.  I can change the I/O base address and the interrupt the controller
>uses, but I don't know what to change them to.  I have tried a few
>combinations, but Xenix is not recognising these.  I would appreciate
>some help here.


Base address of 0x170, interrupt = 37.  You will have to do the low-level
format before changing the settings, as most programs will not recognize
these settings.


JB
-- 
Jonathan Bayer		Intelligent Software Products, Inc.
(201) 245-5922		500 Oakwood Ave.
jbayer@ispi.COM		Roselle Park, NJ   07204