Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!aplcen!haven!mimsy!meyer
From: meyer@mimsy.umd.edu (John R. Meyer)
Newsgroups: comp.unix.xenix
Subject: Logitech Mouse Problems with XENIX-386 2.3.2
Keywords: Logitech Bus Mouse, Device Driver Initialization
Message-ID: <22487@mimsy.umd.edu>
Date: 12 Feb 90 23:00:27 GMT
Organization: University of Maryland
Lines: 25

Hello --

	I just bought a Logitech bus mouse for use with my XENIX
system and I am having trouble with the device driver initialization.
The driver does not usually show up at system boot-up right after
power-on, but it *does* show itself if I boot DOS first.  My
system configuration is:

	-	One serial port adaptor at COM1
	-	Logitech bus mouse at COM2 (interrupt vector 3,
		I/O base addres 023CH, as recommended by Logitech
		installation manual).
	-	Two parallel ports

Anyone have any ideas?

					Thanks,

						John

-- 
John R. Meyer				Domain: meyer@mimsy.umd.edu
10208-C Ashbrooke Ct.			Path:   uunet.uu.net!mimsy!meyer
Oakton, VA 22124 USA			Phone:  (703) 644-3944 (O)
Disclaimer:  The views expressed are my own.	(703) 281-5157 (H)