Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!wuarchive!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!pikes!bscott
From: bscott@pikes.Colorado.EDU (Ben M Scott)
Newsgroups: comp.sys.amiga
Subject: Re: Infinity Machine
Message-ID: <3278@pikes.Colorado.EDU>
Date: 14 Feb 90 07:41:19 GMT
References: <9002132104.AA01561@hydroplane.cis.ohio-state.edu>
Reply-To: bscott@pikes.Colorado.EDU (Ben M Scott)
Organization: University of Colorado, Denver
Lines: 17

In article <9002132104.AA01561@hydroplane.cis.ohio-state.edu> chet@CIS.OHIO-STATE.EDU (eric j chet) writes:
>Hello Out There:
>     Has there been a press release on the Infinity Machine by M.A.S.T ?
>Does anybody have any information on this expansion device for the A500/A1000?

I was talking to the folks at M.A.S.T. for some other reasons and asked them
about this.  Apparently, it's been delayed.  The hardware is finished, but
the cases were milled wrong and had to be sent back to be redone.  This was 
nearly two months ago, however; and I haven't heard anything about it since.
I commented to the guy that I had a Minimegs that didn't FIT on the 500 (too
tall) and was mildly suprised that they even noticed the cases were the wrong
size (I said it nicely, though) and he replied that "we're a lot more careful
about that kind of thing these days."  
 
Apparently, it's not TOO good to be true, but I wouldn't bet money on it yet.

.                              <<<<Infinite K>>>>