Path: utzoo!attcan!uunet!aplcen!jhunix!barrett
From: barrett@jhunix.HCF.JHU.EDU (Dan Barrett)
Newsgroups: comp.sys.amiga.tech
Subject: Re: Kronos 2000 drv. Cont.
Summary: Solution!
Message-ID: <4274@jhunix.HCF.JHU.EDU>
Date: 18 Feb 90 16:42:39 GMT
References: <90021702470269@masnet.uucp>
Reply-To: barrett@jhunix.UUCP (Dan Barrett)
Organization: The Johns Hopkins University - HCF
Lines: 31

In article <90021702470269@masnet.uucp> bruno.pronio@canremote.uucp (BRUNO PRONIO) writes:
>I just recently purchased a Kronos 2000 Drive controller and I am not
>able to low level format the drive. The program that I am using was 
>supplied with the controller (fedX). The program starts up and asks you
>whether or not you want to continue with the format, when I enter
>YES the program aborts and gives me a device error. 

	OK, everybody who has a C.Ltd. SCSI controller -- write this down!
There is an omission in the "SCSI Host/Controller Instruction Manual" that
comes with SCSIDOS 3.0.  It can cause the above error.

	On page 45, "Step by Step Low-Level Formatting of a Hard Drive",
there should be an ADDITIONAL STEP between steps (2) and (3).  (Step (2)
says "Copy your current Mountlist...", and step (3) says "Now start the
FEdX program....").

	Step (2.5):  Run the DevInstall program by typing:

		DevInstall @devs:devsetup

Now proceed with the rest of the instructions.

	This should eliminate the errors you are seeing.

                                                        Dan

 //////////////////////////////////////\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
| Dan Barrett, Department of Computer Science      Johns Hopkins University |
| INTERNET:   barrett@cs.jhu.edu           |                                |
| COMPUSERVE: >internet:barrett@cs.jhu.edu | UUCP:   barrett@jhunix.UUCP    |
 \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\/////////////////////////////////////