Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!ut-emx!linus!ASC.SLB.COM!WYMAN
From: WYMAN@ASC.SLB.COM (Doug.Wyman)
Newsgroups: comp.sys.dec
Subject: Re: help needed setting up a VAXStation 3100
Message-ID: <4206@linus.SLCS.SLB.COM>
Date: 15 Feb 90 23:22:33 GMT
References: <4207@jhunix.HCF.JHU.EDU>
Sender: news@linus.SLCS.SLB.COM
Organization: Schlumberger - ASC, Austin, TX
Lines: 24

In article <4207@jhunix.HCF.JHU.EDU> doug@jhunix.HCF.JHU.EDU (Douglas W 
O'neal) writes:
> I am trying to set up a VAXStation 3100 for a department here and am 
having
> trouble getting it to recognize the scsi disk.  The station and the TK50 
came
> from DEC and I have no problems recognizing the tape drive when it is 
the only
> external device.  However, when I daisy-chain the disk (an ANDATACO 
663MB scsi
> disk), neither devices show up in a show device command.  When I take 
off the
> TK50 and do a show device, I get back that there is a 663MB disk at 
address
> 1 on scsib.  I then do a test 6 (test on scsib) and get a return error 
code
> of 84 = "internal request not set following bus free".
> 
> Has anybody seen/fixed this problem before?  Does anyone have this 
configuration

This sounds very much like both the devices are set to the same SCSI 
address.  It could also
be a SCSI termination problem but less likely.