Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!cica!iuvax!rutgers!aramis.rutgers.edu!topaz.rutgers.edu!msmith From: msmith@topaz.rutgers.edu (Mark Robert Smith) Newsgroups: comp.sys.ibm.pc Subject: WP5.1 and IBM printers problem and solution Message-ID: Date: 14 Feb 90 23:24:15 GMT Reply-To: msmith@topaz.rutgers.edu (Mark Robert Smith) Organization: Rutgers - The Police State of New Jersey Lines: 30 The 11/6/89 version of WordPerfect 5.1 has a problem printing to IBM printers (at least Proprinters) from documents that were created under 5.0 and imported to 5.1. The problem is that all fonts print in half-height mode. There is a workaround, and they will send you an update disk free if you call their Printer number (800) 541-5160. The workaround: Start WP. Enter the Print menu with Shift-F7. do Select Printer, and then highlight the Proprinter and hit 3 for Edit. Go into #4 - Cartridges and Fonts. Select Built-In fonts with RET. Remove the * from each half-height entry. Then, hit F7 twice. Then, hit F7 again, select your default printer and hit 1 for Select. Next, whenever you want to print a document that causes this problem, be sure to put a Font Code at the top of the document, even if it is in the default font. You can do this with Home-Home-Up, Cntl-F8, 4 - Base Font, and RETURN. This fix will work until you get the update fix. The update fix should allow half-height again correctly. Mark -- Mark Smith, KNJ2LH All Rights Reserved RPO 1604 You may redistribute this article only if those who P.O. Box 5063 receive it may do so freely. New Brunswick, NJ 08903-5063 msmith@topaz.rutgers.edu