Path: utzoo!attcan!uunet!wuarchive!texbell!nuchat!uhnix1!crcc!lavaca.uh.edu!zaphod.mps.ohio-state.edu!rpi!gregor
From: gregor@pawl.rpi.edu (Walter Eppenstein)
Newsgroups: comp.sys.mac
Subject: <None>
Message-ID: <2930@crcc.uh.edu>
Date: 19 Feb 90 01:34:28 GMT
Lines: 26

Subject:Mac Monitor
Message-ID: <FF##6M%@rpi.edu>
Sender:gregor@pawl.rpi.edu 
Keywords: debugger, monitor 
Summary:Anyone know the built in debugger commands? 
Organization: Rensselaer Polytechnic Institute, Troy NY
References: <1990Feb10.233412.15585@mathrt0.math.chalmers.se> <5221@ur-cc.UUCP> <132009@sun.Eng.Sun.COM>
Date: 19 Feb 90 01:15:30 GMT
Lines: 17

Hey does anyone know offhand what the commands are fot the debugger that's
called up when you hit the interrupt switch on the side of the machine.
I figured out some from the MacsBug command listing.
(e.g. DM dump memory
	SM change memory
	G Execute at adress
	Dx,Ax,SR Display register x value
)
	Are there any other commadsd or is this all?
	Also where is the debugger stored? in ROM or in system software?
	And how can I substitue my own program in the interrupt service
routine (e.g. get my own routines to run when interrupt is pressed?)

Any reply would be appreciated...

						gregor@pawl.rpi.edu