Path: utzoo!attcan!uunet!seismo!ukma!tut.cis.ohio-state.edu!purdue!decwrl!sgi!markb@denali.sgi.com
From: markb@denali.sgi.com (Mark Bradley)
Newsgroups: comp.sys.sgi
Subject: Re: Power for Iris 220S
Summary: Power--thanks for all the info
Message-ID: <50719@sgi.sgi.com>
Date: 14 Feb 90 17:56:41 GMT
References: <9002140322.AA05845@physics.phy.duke.edu>
Sender: markb@denali.sgi.com
Organization: Silicon Graphics, Inc., Mountain View, CA
Lines: 24

In article <9002140322.AA05845@physics.phy.duke.edu>, rgb@PHY.DUKE.EDU ("Robert G. Brown") writes:

	[ Lot's of information about electrical deleted ]
> 
> The bad news, of course, is that our machine doesn't work (still) and
> it isn't the power :-( But maybe by tomorrow the nice man from SG will
> swap our boards and get us going.

I hope so.  Thanks very much for the informative posting.  As I recall,
the info I posted referred to the power distribution unit receptacles
in the rear of the unit.  Hope that was not too confusing.

						markb

--
Mark Bradley				"Faster, faster, until the thrill of
I/O Subsystems				 speed overcomes the fear of death."
Silicon Graphics Computer Systems
Mountain View, CA 94039-7311		     ---Hunter S. Thompson

********************************************************************************
* Disclaimer:  Anything I say is my opinion.  If someone else wants to use it, *
*             it will cost...						       *
********************************************************************************