Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!uunet!willett!ForthNet
From: ForthNet@willett.UUCP (ForthNet articles from GEnie)
Newsgroups: comp.lang.forth
Subject: LMI Forth(s)
Message-ID: <533.UUL1.3#5129@willett.UUCP>
Date: 23 Feb 90 23:19:05 GMT
Organization: Latest link in the ForthNet chain.  (Pgh, PA)
Lines: 19


 Date: 02-21-90 (15:43)              Number: 455
   To: ALL                           Refer#: NONE
 From: PAUL MOORE                      Read: HAS REPLIES
 Subj: PCFORTH SUPPORT               Status: PUBLIC MESSAGE

 Please help.  I am upgrading some older software to v3.2 and am having a
 bit of a problem with the DOS File Interface.  I have defined HCB's and
 loaded a vaild drive:path\filename into them. The next magical act would
 be to FOPEN the file.  My result so far is always negative.  I have been
 feeding a mode = 0 since the only explanation of mode that I can find,
 under the FMAKE command would suggest that this is the correct value.  I
 have also tried without the drive and path specified, without any luck. 
 Please help me get to that zero flag so I can continue this task. 

 NET/Mail : LMI Forth Board, Los Angeles, CA (213) 306-3530             
-----
This message came from GEnie via willett through a semi-automated process.
Report problems to: 'uunet!willett!dwp' or 'willett!dwp@gateway.sei.cmu.edu'