Path: utzoo!utgpu!jarvis.csri.toronto.edu!cs.utexas.edu!usc!brutus.cs.uiuc.edu!psuvax1!psuvm!cunyvm!ndsuvm1!mtus5!ythprgdb
From: YTHPRGDB@MTUS5.BITNET
Newsgroups: comp.sys.zenith
Subject: Re: Memory for Zenith 386/16
Message-ID: <90055.021812YTHPRGDB@MTUS5.BITNET>
Date: 24 Feb 90 07:18:12 GMT
References: <25.25e40ff0@ubvms.cc.buffalo.edu>
Organization: Computing Technology Services, Michigan Technological Univ.
Lines: 17

We have been looking into third-party (i.e., 16-bit ISE / AT bus) memory
cards to expand our 386/16's as well.  We currently have a BocaRAM AT
board on order.  The tech support at Boca says that the old AT boards
are compatible, but that the newer AT Plus boards have problems.  (too bad,
since the AT Plus has that software setup rather than dip switches :-)

There is a company out there that modifies the Zenith 1 MB boards to
handle 4 MB, but last I heard (about two months ago) the cost wasn't
much cheaper than the Zenith expansion boards.  If you wish, I can dig
up the address for you.

When we get this Boca board, I'll let you know how (or if?) it works.

-------
 -- Noel Maddy                          Bitnet: ythprgdb@mtus5
    MTU Youth Programs                  Snail: 210 Vivian
                                               Hancock, MI  49930