Path: utzoo!utgpu!CUNYVM!IBMTCP-L
Date:	Tue, 27 Feb 90 03:40:59 EST
Reply-To: IBM TCP/IP For VM List <IBMTCP-L@CUNYVM.bitnet>
Sender: IBM TCP/IP For VM List <IBMTCP-L@CUNYVM.bitnet>
From:	Raymond Koluvek <R02RDK@DHHDESY3.bitnet>
Subject:      How to use RPC
To:	UofToronto LAN redistribution <IBMTCP-L@UTORGPU.uucp>
Message-ID: <90Feb27.074344est.58143@ugw.utcs.utoronto.ca>
Newsgroups: list.ibmtcp-l
Distribution: ut
Approved: devnull@gpu.utcs.toronto.edu

I would like to use Remote Procedure Call (RPC) and am looking
for literature in programming techniques with RPC.  I would
like to transform IBM floating-point to IEEE floating-point
numbers for use on our workstations.  In the IBM Manual
"Transmission Control Protocol/Internet Protocol for MVS-
Programmer's Reference"  all routines are mentioned but not how
one may use them.  Could someone point out where I could find
some book on RPC use.

Regards, Ray